![]() Members comply with 2012/2015 IBC, 2010/2013 CBC and are acceptable for use in fire and sound rated assemblies listed in the Code and Gypsum Association Fire Resistance Design Manual. CEMCO Non-structural coldformed steel framing products are manufactured in accordance to the AISI S Specification for the Design of Cold-Formed Steel Non-Structural Members. 1 CERTIFICATION OF MATERIAL Structural Framing and Accessories Product Specification -ASTM C955 (Product) -ASTM C1007 (Installation) Drywall Non load-bearing (Nonstructural) Framing and Accessories Product Specification -ASTM C645 (Product) -ASTM C754 (Installation) Metal Lath & Accessories Product Specification -ASTM C847 (Product) -ASTM C1063 (Installation) -ASTM C1047 (Product) -ASTM C841 (Installation) Steel and Coating Specification for all Product Specification -ASTM A924/A924M (Coating) - ASTM A653/A653M -ASTM A1003/A1003M - ASTM B69 (Zinc Metal Lath) Additional Code Approvals -ICC ESR ICC ESR ICC ESR ICC ESR ATI CCRR ATI CCRR IAPMO ER0126 -PEI AER IAPMO ER LARR IAPMO ER LARR CEMCO structural cold-formed steel framing products are manufactured in accordance with AISI S Specification for the Design of Cold-Formed Steel Structural Members. To purchase the complete standard, go to. Reproduced, with permission, from the ASTM International website, copyright ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. This standard does not purport to address all of the safety concerns, if any, associated with its use. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.ġ.4 The following safety hazards caveat pertains only to the test methods described in this specification. (2.84 mm) in thickness.ġ.2 This specification also covers physical properties and test methods for determining performance requirements.ġ.3 The values stated in inch-pound units are to be regarded as standard. ![]() Scopeġ.1 This specification covers minimum requirements for steel drill screws for use in fastening gypsum panel products or metal plaster bases to steel members from 0.033 in. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. It is informational only and not an official part of the standard the full text of the standard itself must be referred to for its use and application. This abstract is a brief summary of the referenced standard. Surface hardness and ductility of the specimens shall conform to the metallurgical property requirements as shall be determined by microhardness and bend test methods, respectively. The apparatus for testing shall comprise of a power-driven drill screw gun and a vice or a similar device to support the stud during tests. The screws shall be manufactured from Grade 1018 to 1022 steel wire and the screw surface shall be carbonitrided to a specific depth. ![]() This specification covers the minimum requirements, physical properties, and test methods for steel drill screws for use in fastening gypsum panel products or metal plaster bases to steel members.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |